Note:
We recommend
using a termination bar,
primer and drip edge
when installing any
self-adhering flashing.
Strip-n-Flash
TM
Self-Adhering Cavity Wall Membrane
Description:
Strip-N-FlashTM (formerly Peel-N-Seal) is a 40 mil. self-adhering
rubberized asphalt membrane laminated to a high-density
polyethylene film. A siliconized release liner prevents the product
from sticking to itself in the roll. The factory-controlled quality
assures uniform thickness on the job and the name Strip-N-FlashTM
assures an excellent water barrier.
Typical Use:
Strip-N-FlashTM thru-wall membrane is designed to provide moisture
protection in a cavity wall application. Its self-adhesive nature allows
easy installation on concrete, masonry, gypsum, steel and wood
substrates.
Advantages
:
·
The inherent durability of the extra strength 8 mil.
cross-laminated polyethylene film resists mechanical damage
and ensures the integrity of the rubberized asphalt
waterproofing membrane during subsequent wall construction.
·
Strip-N-FlashTM provides a waterproof barrier at flashing areas to
prevent wall assembly leaks.
·
Strip-N-FlashTM is fully adhered to the substrate to prevent
moisture migration behind the flashing.
·
The unique rubberized nature of Strip-N-Flash seals around fasteners.
Limitations:
·
Not recommended in areas where membrane will be subject
to continuous sunlight or temperatures in excess of 180°F.
·
Do not apply primer or membrane to frozen substrates.
Best results are obtained when membrane is installed at
temperatures above 40°F.
·
Do not apply primer or membrane to damp or contaminated
surfaces.
Packing:
12" x 75'
16" x 75'
18" x 75'
24" x 75'
36" x 75'
formerly Peel-n-Seal
Property
ASTM Results
Thickness 40 mils
Tensile Strength D-412 1200 psi. min.
Elongation* D-412 200% min.
Pliability D-146 pass @ -25%
Peel Adhesion D-903 5-lbs./in.. min.
Puncture E-154 40 lbs. min.
Resistance
¼" mandrel
formerly Peel-n-Seal
Technical Data
* % of elongation to ultimate failure of rubberized asphalt
membrane
9